How to Open the Trunk of a VAZ 2107 ~ AUTOTEXNIKA.RU

Occurrence of a problem

Whoever the driver leaves the keys and alarm remote control inside the car due to force majeure events. It’s great if this situation happened in a parking lot and the car’s engine was turned off. But there are times when something similar sometimes happens in a crowded place with the engine running. Finding themselves in this situation, the majority of people have no idea what to do next. In this regard, it is important to know how to behave if the keys are left inside the car

. First of all, you need to calm down, because there is nothing wrong with this. Similar cases happened to almost everyone. Try, first of all, to soberly assess the current situation and only after that begin to act. In doing so, pay attention to the following factors:

How to remove the trunk lock

As soon as a problem occurs in the trunk lock, it is necessary to immediately repair it. To do this, you will need to remove the lid opening mechanism. This is done in order to repair or replace the trunk lock. The procedure for removing the trunk lock is as follows:

Initially, it is necessary to outline the outline of the mechanism, thereby indicating the position of the device on the cover. This is done so that the lock does not need to be adjusted again.
Using a key set to “10”, you need to unscrew the 2 nuts that secure the lock to the trunk.
Now you can dismantle the device from the car, and then, pushing the cylinder inside the cover, remove the core.
The core or cylinder is dismantled together with the spacer bushing.

This is interesting! Particular attention should be paid to the rubber seal, which must be replaced if worn or if there are signs of deformation.

The process is not at all difficult, and it takes no more than 15 minutes to complete. The new cylinder with the mechanism is installed in place in the reverse order of removal. You need to install a pre-lubricated lock on the trunk of a VAZ 2107, but we will learn about this in more detail later.

Replacing the cylinder and installing the trunk lock on the seven

If there is a need to replace the cylinder, then before installing a new device, it must be thoroughly treated with Litol-24 lubricant. Lubrication must be applied not only when installing new parts, but also after repairing old components.

Replacing the VAZ 2107 lock cylinder should be done in the following order:

First install the sealing rubber into the trunk lid. Moreover, it is advisable to replace it if there is excessive wear.
A cylinder must be installed inside the spacer bushing.
Together with the bushing, the cylinder must be installed in the lock (mechanism).
Position the mechanism in the trunk lid, matching it exactly with the marks that were previously marked with a marker.
As a result, you will need to tighten the fastening nuts using a wrench.

At this point, the process of replacing the larva is completed, and you can continue to operate it further. After installation, it is recommended to use liquid silicone grease, which is applied inside the cylinder to lubricate the mechanism.

Adjusting the trunk lock

Often, owners of sevens encounter difficulties when opening the trunk lid. Moreover, they are directly related to the fact that the mechanism jams due to a violation of the location on the lid. The setup process is quite simple:

Loosen the fastening nuts.
Move the device higher or lower depending on the reason why the trunk cannot be opened.
Secure the nut by hand and then tighten it with a wrench.

As a result, it is necessary to check the quality of the device. If there is a gap (between the lid and the trunk walls), jamming, or the device jams when opening, you still need to adjust it. As soon as the mechanism is working properly, you need to mark the position of the lock with a pencil, which will allow you to install it in place the first time next time.

Opening with a button

The ability to open the trunk lid remotely makes the domestic car more comfortable. In this case, there is no need to constantly unlock the lock with a key, since it will open automatically with a button. In addition, such a device will eliminate the development of situations when the lock freezes, and it can only be opened after pouring hot water on it. Making an electric lock on the seven is not difficult, and for this you will need to take the following parts:

Relay with four contacts.
Activator or electric drive.
Wires and button.
Female and male connectors for connecting the circuit.

You will also need electrical tape or heat shrink tubing. Before you start work, you will need to remove the negative terminal from the battery. The principle of implementing the idea is carried out in the following simple way:

It is necessary to supply power from the battery to the relay terminal in accordance with the diagram. Both contacts “87” and “85” must be powered directly from the battery, which will allow you to open the cover even when the ignition is turned off.
From contact “86”, run a wire to one of the button terminals. The second pin of the button must be connected to ground on the car.
From contact “30” of the relay you need to power the activator by applying power to the green wire.
Connect the blue wire from the activator to ground.
Check that the system is working properly.

The activator must accordingly be secured to the trunk lid so that when the armature moves, the lock is affected. As a result, the electric drive for the trunk lock on the VAZ 2107 will be connected and begin to work flawlessly. The button in the cabin is located directly on the panel so that at any time, without leaving the cabin, you can press it and open the lid.

Exiting the trunk lock cable to the passenger compartment

An electric drive for opening the trunk lid is more efficient, however, this method is more expensive than using a cable. The operating principle of the cable is similar to opening the hood. You just need to use a cable several times longer.

To make your idea a reality, you will need the following material:

A cable whose length is 4 m and also has a diameter of 1.2 mm.
Braid of appropriate length that can be used from a bicycle.
Heads for cable.

In order to use the cable to open the trunk lock, it must be routed from the driver's seat to the trunk lid. In this case, a corresponding lever is installed near the driver’s seat, and the second end of the cable must be secured to the movable element of the trunk lock mechanism of the VAZ 2107.

At this point, the process of upgrading the opening of the lock is completed, and you can test its operation. Practice shows that it is easier to install an electric drive to unlock the trunk than to lay a braided cable.

Opening a car using a ruler

It is not always possible to use a spare set of keys and an alarm remote control, so it is recommended to open the car using improvised means. If you don’t have any tools at hand other than a metal ruler, then you shouldn’t despair, because with the help of this ruler you can open the car. This method is as follows: go to the driver’s door and lift the side seal near the lock. Then insert a ruler into the gap between the glass and the door and press it onto the rod responsible for raising the flag. It should be understood that some models of modern cars are equipped with reliable door mechanisms, so it will not be possible to press the rod using a ruler. Manufacturers of such cars provide protection for the door mechanism and attempts to open the door with improvised means will be in vain. However, most cars, including models of the domestic auto industry and many foreign cars, can be opened in a similar way.

Ways to open the trunk without a key

Of course, the easiest way is to use an additional set of keys, but if a duplicate does not exist, contact special companies that provide such services. But the cost of such services cannot satisfy everyone, so we will consider the simplest methods that experienced drivers have already tried on themselves and achieved the desired result.

The most primitive method is to use a sledgehammer and a crowbar, but we will not analyze it, but will consider options that will help open the trunk of a VAZ-2107 from inside the car.

So, if the driver is sure that the keys are left in the trunk and you can freely get inside the cabin, then you can try to get to the keys in several ways:

Dismantling the back of the rear seat. This method is very effective, and it is carried out in the following sequence:

the backrest from the rear seat just needs to be removed;
the plywood stand is also removable to gain access to the small space between the stiffeners and the rear seat back;
into the gap, which is quite a decent size, you need to carefully insert your hand with a hook made of hard wire;
a bunch of keys is hooked and pulled out.

If you cannot find the keys in normal lighting, you should try to insert a small flashlight into the gap to simplify the search process.

Hit the mount that secures the license plate with your hand. This method, according to many, often gives the desired result, although it causes, albeit minor, pain to the driver. If the car owner decides to use this method, he will have to make a sharp blow with his fist in the area where the rear license plate of the car is recorded. Due to a sharp impact, the metal can be deformed, which will allow the inside of the lock to “play”, and the trunk lock will simply open.

Craftsmen assure that you can open the trunk of a VAZ-2107 using various available means, for example:

strong, but not very thick wire;
a nail file for polishing nails, of course, if it is made of metal;
with an ordinary awl. Using an awl, pierce the seal that is provided around the entire perimeter of the trunk. Next, you need to find by touch the location of the “tongue” of the lock and try to move it away. If this process is successful, the trunk lock will simply open.

Use a screwdriver to open the trunk. This method is used only if other methods do not give the desired result, since the lock is most often opened with a screwdriver, but it has to be changed due to a broken cylinder. But, despite this, many car owners use a screwdriver to open the trunk without keys, convincing themselves that replacing the lock with a new one is a fairly simple and hassle-free task.

Which method to choose to open the trunk of a VAZ-2107, of course, every car owner must decide on his own, and the video instructions on the Internet resource will help you get any answers on this topic and clarify the most incomprehensible things, which you can watch at the most convenient time for yourself.

Quick solution to the problem

If you don’t have time to fuss with opening the doors, then, as a last resort, you can break the glass with a brick or stone. True, then you will have to replace the broken glass, which will cost a lot of money. You can also cut out the seal. In this case, the glass will not be damaged, the machine will be open, but to do this you will need a stationery knife. In addition, you will need to purchase a new seal, so you should think in advance where suitable seals are sold. Do not forget that the driver of a domestic vehicle will be able to find the necessary seal in the first auto store he comes across. Owners of old foreign cars will have a hard time in this situation.

How to open a car door using a ruler.

Help from specialists

If it was not possible to open the car using the above methods or there is no time for this, then you should seek help from professionals. However, you should understand that, despite the speed of solving the problem, you will have to pay a certain amount. If necessary, specialists will open the hood or trunk and also give the client some advice. Therefore, remember that if you accidentally slammed the car or closed the trunk, dropping the keys, then you should not worry, since similar situations arise with everyone nowadays. In most situations, the driver will be able to open his own car.

how to open

VAZ
2107 door without a key
video Anyone who owns a car has encountered an obvious situation: the doors are locked, and the car keys are in the cabin. With all this, the saving 2nd set of keys, which, by the way, not everyone has, of course, may be located at the other end of the town and there is no time for a long trip in public transport or to find a friend who will take you there and back. You shouldn't panic about opening a car door without keys, of course. How to open a car without a key? For this purpose you need to hack it. Before you start picking the lock of your own car, you need to explain to the people who are currently nearby (working in adjacent stores or other institutions) what you are trying to open

own car. This is due to the fact that vigilant citizens call law enforcement officers when they see the actions that are taken to open a car without a key, when you try to open an insignificant one using this method.

How to open a VAZ2107 without a key

Hello. On my channel you need to have a great conversation while watching good videos

on various topics.

Next, at one end of the found wire we make a hook at an angle of 45 and about 2 cm long. After completing the preliminary work, we proceed to opening the lock. We plant the formed hook into the gap between the door and the glass.

If the wire rests against an obstacle (usually a locking device mechanism), we bypass the lock and search for a special mechanism to open the door. This is done in this way: without weakening the pressure on the wire when it rests against an obstacle, we move the hook to the right side right until the moment it falls through. After a while, we turn it to the right.

We find the mechanism for locking the lock, which without experience is done through countless attempts. If this mechanism has been found, then hook it with a hook and pull the wire. The lock should open. For those who are still wondering how to open a car without a key at home, we offer the 2nd method: You can open a car lock without a key by using a narrow rope along another fishing line (these things are definitely found among those guys who do). For this purpose, it is necessary to perform the following steps: At the base of the selected rope, or fishing line, we tie a loop, which must be the size of the internal door lock button.

Tuning VAZ 2106 → How to open the trunk.

Friends need help. The lock in the trunk is broken. I tried, I tried, but I couldn’t open it with the key. How can you open it without a key?

Maxim_Gaynanov
October 30, 2011, 11:06

Roma_Popov
October 30, 2011, 11:11
v

Maxim_Gaynanov
October 30, 2011, 11:12
v

Alexandr_Lalenko
October 31, 2011, 11:45
v

Vengr_Pokrovskiy
31 October 2011, 13:25
v

Vagon_Bichkov
31 October 2011, 14:33
v

Nikolay_Zolotuhin
31 October 2011, 14:59
v

Jei_Nikolaenko
31 October 2011, 16:05
v

Vagon_Bichkov
31 October 2011, 16:54
v

Nik_Jigalov
01 November 2011, 19:15
v

Forever_Zelenskiy
01 November 2011, 19:45
v

Jei_Elantsev
02 November 2011, 00:06
v

Vitk_Shpak
02 November 2011, 20:39
v

Vengr_Kucherenko
02 November 2011, 21:44
v

Jigalov is correct, we opened it like this, two people standing on the sides pull the trunk up, and one kicks the place where the number should be, everything opens. We took off the number and put a thick rag under it, so as not to scratch it; why not roll up a branch?